Biref introduction:
ZTD flue fuel desulfurization pump was elaborately created to satisfy the demands of damp method FGD of limestone(lime) and gypsum for coal fired electricity plants.The hydraulic types of ZTD desulfurization pump is optimized made by CFD,and its passage is made below the theory of abrasion of slurry pump.The wetted areas materials for ZTD desulfurization pump is an anti-abrasive and anti-corrosive content which was designed by HangZhou Pump alone. The biggest diameter of ZTD series is 900 mm at present, and it is commonly utilised in the flue fuel desulfurization and denitration approach of electrical power plant and other atmosphere security tasks. 

Parameters:

1. Flow rate:Q=seven hundred~14000 (m³/h)
2. Total head:H=15~63 (m)
3. Pace:n=420~980rpm
4. S.g.:γ ≤1.5 
5. Temperature:T=~120ºC 
6. Pump diameter:three hundred~900mm

Features:

1. Elaborately designed based on the characters of flue gas desulfurization of thermal power plant to meet the requirements of a facility below 1000 MW.
2. CZPT models are CFD optimized to have excellent performance of anti-cavitation.
3. Specially designed mechanical seal for flue gas desulfurization process. 
4. The impeller position can be adjusted by the bearing housing,this brings a shortcut to recover the pump performance under a slightly abrasion.
5. Axial adjusting structure to maintain the distance between impeller and front cover plate to keep a high efficient operation.
6. The specially designed anti-corrosive and anti-abrasive duplex stainless white iron for FGD process,which has the advantages of both duplex stainless steel and white anti-abrasive iron alloy.

Composition:

1. All metal materials for pump set,without any lining rubber or other high polymer material.
2. Pump casing adopts duplex stainless steel of 2605N and 2205,which have excellent resistant performance of chloride ions and sulfate ions,and therefore is the first choice of desulfurization pumps.
3. Front and back open structure,the rotary part can be removed from the casing without dismantling the pipelines.
4. Cartridge mechanical seal with internal or external flushing plans.
5. The bearing part is back pull structure,which is assembled in the bearing housing.
6. Transmission: directly coupled and gear box drive.

Structure drawing is as below

1.bearing cover 2.filler cover 3.shaft 4.filler 5.vice-impeller 6.pump body 7.impeller nut 8.front pump cover 9.impeller 10.back pump body 11.shaft sleeve 12.bearing box 13.bracket 14.bearing box 15.bearing 16.bearing gland 17.shaft 

Configuration:

Software:

1. Mainly used as circulation pump of gypsum slurry of absorbing tower of FGD process.
2. Slurry pump of ammonium phosphate
3. Other applications of big flow rate and low head.